MAXREST

Surface Preparation:
Surface should be clean and free of dirt, grease and loose particles. Remove all damaged and unsound concrete to expose a structurally sound substrate. Expose all reinforcement affected by rust. Remove concrete all around the bars for an efficient cleaning and to surround it with a minimum thickness of at least 1 cm of MAXREST. Eliminate rust by wire brush, needle gun, sand or shot blasting, etc. Apply slurry coat o f Maxrest or oxide converter MAXREST PASSlVE (Technical Bulletin nº 12). After cleaning, wash the concrete with water. Before applying MAXREST, wet the surface but do not leave free-standing water.

Mixing:

A 25 kg bag of MAXREST is mixed with between 3,5 to 4,0 litres of clean water, depending on the ambient conditions and the consistency required, either manually or mechanically by low speed drill (400 - 600 r.p.m). MAXREST takes fifteen to twenty minutes to set, depending on the temperature. Mix only the amount of MAXREST that can be applied within eight to ten minutes.

Application:
For an optimum bond, prepare a slurry mixing 5 parts of MAXREST with 1 part of water, mixing well until achieving a homogeneous consistency without any lumps. Apply the slurry using a MAXBRUSH type brush on the surface to be repaired and on the reinforcement bars, filling all voids and pores, allowing 5 to 8 minutes before continuing the repair. While the slurry is still fresh, start placing MAXREST with its consistency of repairmortar. Apply in successive layers between 2,5 and 3 cm, scratching the surface with the trowel to make the next layer adheres firmly. Between layers, wait 10 to 15 minutes depending on temperature. If the different layers become warm, wet the surface with cold water.

Application Conditions:

Do not apply at temperatures below 5 ºC or if lower temperatures are expected during the 24 hours following the repair. Do not apply on frozen or frosted surfaces.

Curing:

For better curing once the job is finished cover with wet cloth to protect from high temperature or direct hot sun.

Cleaning:

Clean all tools and equipment immediately with water after use. Once MAXREST hardens it can only can be removed by mechanical methods.

Consumption:

Estimated consumption of MAXREST approximately 1,67 kg/m2 per 1 mm thickness. One kilogram of MAXREST will fill approximately 0,6 litres.

Packaging:

MAXREST is supplied in 25 kilogram drums and bags, and 5 kilogram cans.

Storage:

Nine months in bags, twelve months in drums and cans, in their unopened original packaging, in a dry and covered place protected from damp and frost, with temperatures above 5 ºC.

Important cautions:

• Do not use leftover mixed material to prepare a new batch

• Do not add sand, aggregates or cement to increase volume

• Do not use high speed mixers

• Do not mix for prolonged periods

Scratch the surface Finish the edge Final finish

• Do not apply on painted or structurally weak surfaces

• Do not apply in layers exceeding 3 cm thickness

• Do not allow the layers to heat up; Mist spray with water if required

• Setting time ismeasured at 20 ºC.Higher temperatures reduce the setting time and lower temperatures delay the setting time

• With low temperatures keep the product in a warm place and use lukewarm water to accelerate the setting time

• With hot temperatures keep the product in a cool place and use fresh clean water for the mix. Wet the different layers. Mix small batches of material and apply immediately

• For further information consult our Technical Department

Safety and health:

MAXREST is non-toxic but as all cementitious product it is an abrasive compound. Rubber gloves and safety goggles must be used to mix and apply the mixture. In case of skin contact, wash affected areas with soap and water. In case of eye contact, rinse with clean water but do not rub. If irritation continues, seek medical attention. Safety Data Sheet of MAXREST is available by request.

Disposal of the product and empty packaging must be carried out according to national regulations by the final user.